TOPS Swift-Splice™ (FM) and (NFM)
Belt Splicing Solutions
The TOPS Swift-Splice is designed to mechanically clamp together the ends of most rubber and PVC elevator belts that are on the market today. Because of the various belt applications and tension ratings, we have engineered two versions of this splice.
Our most common version of the Swift-Splice is known as the TOPS Swift-Splice (FM) which is constructed of a ferrous metal and will accommodate belt tension ratings up to 800 PIW. Our TOPS Swift-Splice (NFM) is constructed of a non-ferrous metal and rated for belt tensions up to 1200 PIW. This splice is also “non-sparking” option.
When ordering or requesting a quote please have the exact belt width available. This information will allow a T.O.P.S. staff member to correctly quote or place on order, the correct amount of TOPS Swift-Splices you will need to complete the job.
Technical Data
TOPS Swift-Splice (FM)
*Clamping Style Splice
*One Splice for every two inches of belt widt
*Ferrous Metal Construction
*800 PIW Max Belt Tension Rating
*Max Operating Temp 600° F
TOPS Swift-Splice (NFM) ---- Non-Sparking!
*Clamping Style Splice
*One Splice for every two inches of belt width
*Non-Ferrous Metal Construction
*Non-Sparking Belt Clamp Solution
*1200 PIW Max Belt Tension Rating
*Max Operating Temp 800° F
TOPS Swift-Splice Installation Instructions w/ Template:
-
Inspect both belt ends to be sure they are square; if not trim.
-
Peel and squarely stick provided splice marking template to end of one belt side. This template will provide you the marking for drilling / punching splice holes.
-
Take both belt ends and clamp them together so they do not shift, then proceed to drill / punch for ½” bolts through both belt ends.
-
Visually inspect for proper hole placement; being sure everything is square.
-
Inspect TOPS Swift-Splice and you will notice two gripping areas on both end plates A & B. The slotted end is mounted towards the face of the belt and the end with gripping teeth will be mounted towards the tail of the belt.
-
Place the center plate between both ends of the belt. The wide end faces belt face per drawing.
-
Once all three plates are aligned, use provided hardware and tighten. 600 PIW belt or less torque to 75 ft.lbs; 600PIW and over use 100 ft.lbs.
-
Visually inspect that everything is correct and install elevator belt.
-
Run elevator for 30 minutes then re-torque to above specifications.
WARNING: Not Approved for Manlifts! T.O.P.S. Inc. strictly prohibits the use of the TOPS Swift-Splice (FM), TOPS Swift-Splice (NFM) and TOPS Bar-It (NFM) on manlifts as these splices have not been approved or tested for this application. By installing death or serious injury may occur.
WARNING: The TOPS Swift-Splice (FM), TOPS Swift-Splice (NFM) and TOPS Bar-It (NFM) are not recommended for use in elevators with wing pulleys. By using them in this application you may notice premature wear on the back side of the belt around splice and / or noise in the boot section as the pulley may contact the splice.
WARNING: Do not re-use hardware. Please contact T.O.P.S. Inc. for replacements.
WARNING: Not for use on steel cable belts!
Need a distributor in your area? Please contact T.O.P.S. Inc. at 877-326-4704!!